Sold prices, recorded weekly ยท Nov 19, 2026

The Outboard Price Almanac

Used outboards, lower units and powerheads

Articles

How to match a used lower unit to your outboard

Shaft length, gear ratio, rotation and model codes: the four things that decide whether a used lower unit fits, and how to find each one on your motor.

Nov 18, 2026

A lower unit is the gearcase below the waterline: the propeller shaft, the gears that drive it, and the water pump. It is the part most often destroyed by a rock, a stump or a sandbar, and a used one is often the cheapest way to get a motor running again. It has to match your motor in four ways.

1. The motor's model and serial

Start with the ID plate on the motor's transom bracket or swivel bracket. It gives the model code (on Yamahas, an X in the code means a 25-inch shaft and an L means 20-inch, as in F150TXR and F150TLR) and the serial number. Manufacturers change lower units at serial-number breaks, not at model years, so the serial is what a good seller will ask for.

2. Shaft length

Measure from the top of the transom bracket, where the motor clamps or bolts to the boat, straight down to the flat anti-ventilation plate above the propeller.

NameMeasurementCommon on
Short (S)about 15 inSmall motors, small boats
Long (L)about 20 inMost mid-size single-engine boats
Extra long (X / XL)about 25 inOffshore boats and many twin setups
XXLabout 30 inLarge offshore boats

On many motors the shaft length is set by the midsection, not the lower unit, so a 20-inch and a 25-inch motor can share a gearcase. On others it cannot. Ask the seller which midsection their unit came from.

3. Gear ratio

Gear ratios differ between motors of the same horsepower family and sometimes between years. The wrong ratio changes how the motor performs with your propeller. The ratio is usually stamped or listed with the part number; ask for it.

4. Rotation

Most single motors turn the propeller clockwise (right-hand). Twin and triple setups often use a counter-rotating motor (left-hand) on one side so the boat tracks straight. A counter-rotating lower unit is a different part and usually costs more. Check whether yours is standard or counter-rotating before you shop.

Before you install it

  • Fit a new water pump impeller. It costs little and an old one is the usual cause of overheating.
  • Drain and refill the gear oil, and look at what comes out of the used unit.
  • Pressure- and vacuum-test the gearcase if your shop can. It finds bad seals before the water does.