Checking a used outboard: hours, compression and the gear oil
What an engine-hour report shows, how to read a compression test, what the gear oil tells you, and the other checks worth doing before you pay for a used outboard.
An outboard can look clean and run at the dock and still be close to failing. These checks take an hour with the seller and catch most expensive problems.
Engine hours, and how they were spent
Modern Yamaha, Mercury and Suzuki four-strokes record their hours in the engine computer. A dealer with the brand's diagnostic software can print a report that shows total hours and how they were split across engine-speed bands. A motor with a lot of hours at full throttle has worked harder than one with the same hours at cruise. Many sellers will pay for this report, or let you pay for it, when the deal is serious.
Compression
Ask for a compression test on every cylinder, done warm with the throttle open. The absolute numbers vary by model; what matters most is that the cylinders are close to each other. One cylinder well below the rest points to a worn ring, a burnt valve or a head-gasket problem.
The gear oil
Have the seller loosen the lower drain screw on the gearcase. What runs out tells you a lot:
- Clean, amber or dark oil: normal.
- Milky or gray: water is getting past a seal. Fixable, but it needs doing.
- Fine metallic glitter or chunks: gears or bearings are wearing. Budget for a lower unit.
Everything else
- Corrosion. Look under the cowling and around the lower unit, especially on saltwater motors. Bubbling paint at seams is corrosion underneath.
- Cooling. Run it on a flusher or in a tank and check for a strong telltale stream of water.
- Shifting and trim. It should shift cleanly into forward, neutral and reverse, and the power trim should move smoothly up and down.
- What is included. Controls, wiring harness, gauges and the propeller. Rigging a motor from scratch is a real cost.
Once you know the motor's condition, compare its asking price with the sold prices for that motor.